Emes Quartz Powered/Active Studio Monitors Factory Matched Pair 6 Immaculate
Used and in immaculate showroom condition. Like new in original packaging with original manual.
These are excellent powered monitors, but just too big for my new desk. Will include Mopad Isolators and cables. Made in germany, theses are rare and superb speakers for mixing or mastering. The EMES QUARTZ is the big version of the KOBALT Nearfield monitor.
The second of a new generation 2 way bi-amplified near field Monitor, specially designed to meet the best performance at a reasonable price point. Well known EMES HR line features are found in the QUARTZ plus added features like. The BI-PortT and the ISO-RailsT. The BI-PortT was specially designed to keep the cabinet dimensions as small as possible, while supporting the High frequency section.Therefore we integrate the 25mm Neodymium Tweeter In the Center of the BI-PortT (Bass Reflex System) for two reasons; To aim for an efficient Air cooling of the "little tweeter" by the Woofers Air flow, secondly and most important to generate a "velocity field (ring shape)" around the Tweeter to support it's High frequency dispersion pattern over long distance! (riding on along wave) Result - an unbelievable precise Stereo-Image over distance. Also the ISO-RailsT are features which have practical aspects as well as acoustical once!
Most available cabinets have flat sheet surfaces, such speakers have hard times to stick on the location they were placed on, especially when they are pushed hard, manually or by the moving force of the Woofer! Not such strange things happen to the KOBALTs! The cabinet is standing on the ISO-RailsT - a special silicon profile - only.
So there is no coupling to surface underneath nor is any "slip" behaviour going on, so the low end is always tight at any time! As always at EMES, matched high quality drivers are chosen, because to us they are the most critical part in a quality Studio Monitor System! The Low range (59 - 2000Hz) is reproduced by a 17cm polypropylene Membrane HDS-driver. A 25mm high efficiency Neodymium Tweeter located in the BI-PortT is used from 2 - 20 kHz! We at EMES always use identical amplifiers, to have the lowest time related distortion possible! Therefore 2 identical build in 80W rms amplifiers which deliver a powerful and optimized output drive a single QUARTZ Monitor.This is one of the many design criteria's to the EMES audio performance. To adjust the monitor to your personal listening level, a 16 position dip-switch has been added!
This allows to control the midrange performance as wel as to adjust the listening level!